Tie-FenLock 100 Depot Control System


The Tie-Fenlock 100 DCS is the entry level system of the Tie-Fenlock series, providing a simple and compact depot control solution.

Fenix Signalling recommend the Tie-FenLock 100 DCS for small, simple depot layouts where a centralised control system is deemed unnecessary and plungers can be safely and easily accessed

Example of Operation

The Tie-FenLock 100 is a simple system intended to be operated by a single shunter (or other depot staff) in conjunction with standard depot hand signalling to partially automate depot operations.

Start Finish
The shunter will or should walk to the relevant plungers in the path to the desired siding and press them to operate the points to the correct lie.

Alternatively, keyswitches can be installed on the side of the equipment or PPI housing to allow operation.

The point machine then operates. The PPI begins to flash and continues to flash until detection is achieved.
The shunter will or should’ then check that all point lies are correct and begin hand signalling the driver at their discretion